Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed

["Kris Merschrod" <Kris@merschrod.net>]

I did the mod from the schematic and parts that T-T sent on a perfboard - it 
really isn't much, but, before hand,  I pulled the 15 meter filter and put 
in a jumper wire - it worked like a charm w/o the filter - I am not sure 
what the harmonics on that looked like - others can do the hi-tech work :>)
Kris
----- Original Message ----- 
From: <w8au@sssnet.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, February 13, 2014 1:39 PM
Subject: Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed


> At 08:10 AM 2/13/2014, you wrote:
> > I just acquired a Ten Tec Centaur 411 amp from an SK estate.  As it turns
> > out, it was never updated for 12/10m use.  Ten Tec noted they did not have
> > the board to enable 10m.  Any suggestions on a possible source or circuit
> > diagram would be appreciated.
> Doug:
>
> Had to do this to our club Centaur.  TT no longer has the plug in board 
> but
> will supply the pi-section filter schematic/parts values for it.  You have 
> to
> fabricate your own board, which goes in place of the 15 meter output 
> filter.
> Have fun..
>
> Perry   w8au
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec