At 02:48 PM 2/13/2014, Kris Merschrod wrote:
I did the mod from the schematic and parts that T-T sent on a
perfboard - it really isn't much, but, before hand, I pulled the 15
meter filter and put in a jumper wire - it worked like a charm w/o
the filter - I am not sure what the harmonics on that looked like -
others can do the hi-tech work :>)
Ooops... there goes the FCC type approval.. ;-) (hope your antenna
was selective)
Perry w8au
----- Original Message ----- From: <w8au@sssnet.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, February 13, 2014 1:39 PM
Subject: Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed
At 08:10 AM 2/13/2014, you wrote:
I just acquired a Ten Tec Centaur 411 amp from an SK estate. As it turns
out, it was never updated for 12/10m use. Ten Tec noted they did not have
the board to enable 10m. Any suggestions on a possible source or circuit
diagram would be appreciated.
Doug:
Had to do this to our club Centaur. TT no longer has the plug in board but
will supply the pi-section filter schematic/parts values for it. You have to
fabricate your own board, which goes in place of the 15 meter output filter.
Have fun..
Perry w8au
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|