Take a 4x6 inch card and start at the back, holding card vertically, only
exposing 1/4 of the board at a time...as you go across, put the dryer to it,
and if it comes on-or goes off, remove heat and do same from left to right
after it comes back on (or off) again. I also had a fan to cool it as mine
would only work when hot.
Just a suggestion, but I did it and found a one inch area which was where the
problem was.
I sent it to Dollywood 3 times and they could NOT duplicate the issue......?
It ALWAYS was off till the rig was on an hour or more......Their service area
must be 100 degrees or more. 3 times...new box each time, and I am sure that
they never opened the box the 3rd time. I was really ticked, and I fixed it in
5-10 minutes once I tried to do it.......shameful.
Best of wishes.
Mark
K8VF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|