I've had relay problems with my Paragon that causes it to lose receive
sensitivity. Transmitting into a dummy load for a few seconds cures it
for me.
73,
Bob WB2VUF
On 5/25/2016 3:04 PM, k7mks@comcast.net wrote:
My Paragon has an intermittent problem in receive where the S Meter reading
decreases rapidly as does the volumn of whatever station I am tuned to
regardless of band, frequency, or mode. The decrease is instantaneous and can
be short lived and has been corrected a couple of times by tapping on the case.
I suspect a poor/cold solder joint somewhere. At times it will receive for
hours without a problem. I'm beginning to suspect that the First Mixer Board
(#81331) may be the culprit and would welcome your thoughts
Thank you Joe k7mks
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|