I have a complete and fully functional relay board and output low pass filter
board for a Paragon if anyone has a need.
Gary
> On Jun 4, 2016, at 10:41 AM, Bwana Bob <wb2vuf@verizon.net> wrote:
>
> I've had relay problems with my Paragon that causes it to lose receive
> sensitivity. Transmitting into a dummy load for a few seconds cures it for
> me.
>
>
> 73,
>
>
> Bob WB2VUF
>
>
> On 5/25/2016 3:04 PM, k7mks@comcast.net wrote:
>> My Paragon has an intermittent problem in receive where the S Meter reading
>> decreases rapidly as does the volumn of whatever station I am tuned to
>> regardless of band, frequency, or mode. The decrease is instantaneous and
>> can be short lived and has been corrected a couple of times by tapping on
>> the case. I suspect a poor/cold solder joint somewhere. At times it will
>> receive for hours without a problem. I'm beginning to suspect that the First
>> Mixer Board (#81331) may be the culprit and would welcome your thoughts
>>
>> Thank you Joe k7mks
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|