| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 15 Aug 2018 00:35:20 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
It goes between the BPF/Front End Board's RX IF OUT and the 9MHz Xtal Filter Board's RX IN (cable "25") Barry N1EU On Tue, Aug 14, 2018 at 11:46 PM, Curt Benjamin via TenTec < tentec@contesting.com> wrote: > Greg, where in the Omni VI circuitry does that filter go? > Curt, K8AI > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit, Curt Benjamin via TenTec |
|---|---|
| Next by Date: | Re: [TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit, Greg S via TenTec |
| Previous by Thread: | Re: [TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit, Curt Benjamin via TenTec |
| Next by Thread: | Re: [TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit, Greg S via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |