Yup. Thanks, Barry. Pretty easy install. Solder 1 wire to an existing resistor
lead, and install a ground lug under a corner screw on one board. The rest are
plug in connectors. In case anyone was curious.
Greg, KC8HXO
Sent from my Linux device
> On Aug 14, 2018, at 20:35, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> It goes between the BPF/Front End Board's RX IF OUT and the 9MHz Xtal
> Filter Board's RX IN (cable "25")
>
> Barry N1EU
>
> On Tue, Aug 14, 2018 at 11:46 PM, Curt Benjamin via TenTec <
> tentec@contesting.com> wrote:
>
>> Greg, where in the Omni VI circuitry does that filter go?
>> Curt, K8AI
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|