Topband
[Top] [All Lists]

RE: Topband: MFJ-1026 noise canceller

To: "Jim McDonald" <jim@n7us.net>, <topband@contesting.com>
Subject: RE: Topband: MFJ-1026 noise canceller
From: "Bob Tellefsen" <n6wg@earthlink.net>
Date: Tue, 30 Dec 2003 14:48:43 -0800
List-post: <mailto:topband@contesting.com>
Jim
Both the ANC-4 and the MFJ-1026 have provision for an external input
to handle the TR switching.  If your rig provides a switched ground
output, it can be used to the switch the noise canceller in and out
of the line faster than waiting for the internal rf detector to do
the job.
My K2 provides the TR switchg output a few milliseconds before rf
starts coming out the spout, so gives my MFJ-1026 time to switch.
Good luck and 73
Bob N6WG

-----Original Message-----
From: topband-bounces@contesting.com
[mailto:topband-bounces@contesting.com]On Behalf Of Jim McDonald
Sent: Tuesday, December 30, 2003 5:57 AM
To: topband@contesting.com
Subject: Topband: MFJ-1026 noise canceller


Any opinions on the MFJ-1026 noise canceller?  Fast enough TR switching for
QSK?  TR switching relay noise?

I tried a JPS ANC-04 and didn't like it, primarily due to the fixed (via
resistor) TR delay time.

Thanks.

Jim N7US


_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>