Topband
[Top] [All Lists]

Re: Topband: Polyphaser IS-50UX-CO vs ICE Model 303?

To: "chacuff" <chacuff@cableone.net>
Subject: Re: Topband: Polyphaser IS-50UX-CO vs ICE Model 303?
From: "Tom W8JI" <w8ji@w8ji.com>
Reply-to: Tom W8JI <w8ji@w8ji.com>
Date: Mon, 21 Jan 2013 10:41:47 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>

Could that not be said of any inline protection then?


Almost, anything but a disconnect.

Also, while we sometimes go wild with grounds, nearly ALL of the protection (or lack of protection) comes from how things are bonded and common grounded going into the protected area.

I can't stress the point that a proper entrance and proper ground bonding, so everything rises together without high current loops through equipment, is nearly 100% of actual protection.

My towers take at least one hit in every lightning storm, and other than RF ground radials on my four square area, I have no fantastic grounds. My 318 foot tower has eight deep-buried number 6 or 8 gauge copper radials about 50-100 feet long, interspersed with around thirty #16 shallow bare wires from when I fed the tower as a vertical. It has only a few ground rods.

http://www.w8ji.com/Antenna%20grounds.htm

The house has a buried perimeter conductor, but almost no ground rods.

I never have lightning damage inside buildings. Not one piece of consumer gear has ever been damaged. Never lost a modem.

Despite what we sometimes hear, nearly all protection comes from how entrances are constructed and bonded. The worse thing in the world is an entrance ground that is not connected to the power mains ground.

73 Tom
_________________
Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>