Re: Topband: [TowerTalk] RG-6 Delay cables

[Steve Maki <lists@oakcom.org>]

Any connector with a captured (non-solder) center pin will accomplish 
this, such as the Times EZ series (EZ-400-NM, etc) or many of the 
corrugated hardline connectors. As long as the connector was not 
installed in cold weather with the center conductor pushed in as far as 
it will go. If the cable is prepped according to the instructions, that 
won't happen.
-Steve K8LX

On 04/08/20 17:11 PM, Lee STRAHAN wrote:
> Robin WA6CDR mentioned this to me in an earlier exchange this AM. It was not 
> me. Should have mentioned that before. Sorry Robin, You the Man!
> Lee   K7TJR
>
> -----Original Message-----
> From: Richard (Rick) Karlquist <richard@karlquist.com>
> Sent: Wednesday, April 8, 2020 2:00 PM
> To: Lee STRAHAN <k7tjr@msn.com>; topband@contesting.com
> Subject: Re: Topband: RG-6 Delay cables
>
>
>
> On 4/8/2020 1:28 PM, Lee STRAHAN wrote:
>
> >      Even if the copper center conductor expands, the way the cable connectors 
> > are made allows the copper to simply push in the connector  past the connection 
> > point maintaining its physical length.
> Very astute.  You may have explained this paradox.
> I didn't think of this type F effect.  Some type N connectors also work this 
> way.
>
> 73
> Rick N6RK
>
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector