Towertalk
[Top] [All Lists]

[TowerTalk] Re: Guy wire interaction

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: Guy wire interaction
From: n7cl@mmsi.com (Eric Gustafson)
Date: Sat, 10 Apr 1999 10:53:11 -0700

>From: "Clive Penna" <clive@gm3poi.prestel.co.uk>
To: <towertalk@contesting.com>
>Date: Sat, 10 Apr 1999 08:08:13 +0100
>
>"However, besides rescaling the wire lengths, a frequency scale
>will also change the diameters.  While this may have a small
>effect on the model behaviour, I'd reset the wire diameter after
>the rescale for best accuracy."
>
>73, Eric  N7CL
>
>Hi Eric,
>
>Eznec does not appear to rescale the wire Dia unless it is
>quoted in inches.  If you stick to wire# it does not rescale the
>Dia. 73 Clive GM3POI
>


Right you are Clive!

I had just assumed that Tom would enter guy wire diameters in
inches rather than as AWG numbers.  So, what is the AWG number
for 5/16" EHS guy wire anyhow?

73, Eric  N7CL


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>