Hi:
> << I have a J-Pole design sheet that gives all the formulas for constructing
>
> this Vertical Antenna in the VHF regions.
>
> My Question: Is the J-Pole limited to the higher frequencies, or can it be
> also be used in the HF spectrum?
>
> If so, will the formulas work at these lower frequencies? >>
Yes, and . . . A "J pole" antenna is a 1/2 wavelength antenna feed by a 1/4
wavelength stub, total length + 3/4 wavelength. (shorted on one end and open on
the other, one side connected to the end of the 1/2 wavelength radiator, with
the feed line connected at the point between zero Ohms of the shorted end and
the
10 k Ohms of the open end that matches the feed line impedance.
Total length = 3/4 wavelength. If the Super "C" antenna from `GAP' doesn't pan
out,
I plan on erecting a very light weight (thin) tower 100' high and mount a 1/4 WL
(30 feet) pipe 2-3 inches away, shorted at the bottom open at the top and fed
50 ohms up from the (bottom) bonding connection. (base grounded for lightning)
60 feet of radiator (the tower 6-8" face) will resonate at 7.0? mHz, (not 64,
as is
used for wire antennae) with 30 of stub below it, bonded to the tower 10 feet
up.
A 40 meter "J pole." Putting a 10' pipe inside at the top (a foot or so
sticking
out) and moved up out of the tower, held with hose bands will allow it be tuned.
Formula not needed at these frequencies.
73 (= Best Regards) de: Ron ka4inm@qsl.net
VISIT my HAM WEB SITE at: http://www.qsl.net/ka4inm
using LINUX here & loving it!
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|