At 23:10 6/25/2002 -0400, Jim White wrote:
>check scrap yards when sourcing - it is a heck of a lot cheaper -found some
>nice ones rusting was able to obtain for a song once upon a cycle....as hams
>we need not be exactly critical in what we want but should someone have
>something similar ham ingenuity will prevail!
Yep - check the scrap yards before shopping for new "I" beams. In either
case - get the scrap/steel yard to have a torch man cut one end of each "I"
beam at about a 45 deg angle. Then after you drill holes just inside the
angle cut you have a built-in guy wire equalizer plate to attach turnbuckles.
73 Phil NA4M
-. .- ....- -- -. .- ....- -- -. .- ....- -- -. .- ....- -- -. .-
....- --
Phil Duff NA4M na4m@arrl.net Georgetown, Texas
|