Just pour concret over the whole length of tower then who cares if it rusts.
I am sure someone will point out the error of my humor, like the amount,
size, bends and type of rebar that would be needed and the grounding that is
required.
If you do not have a tower you won't have to worry about it falling down.
Tom
----- Original Message -----
From: <n4kg@juno.com>
To: <TOWERTALK@contesting.com>
Sent: Tuesday, October 08, 2002 11:07 AM
Subject: Re: [Towertalk] Cracked Leg on Rohn 45G
> Obviously we are in disagreement over the magnitude
> of the HORIZONTAL Forces at the Base of a Guyed Tower.
> Please explain the origin of the horizontal forces you are
> concerned about acting on the base.
>
> My contention is that they are quite small (and insignificant)
> compared with the vertical forces. THAT (and NOT LUCK)
> is why towers with minimal lateral support at the base
> do NOT fall down.
>
> Any mechanical or civil engineers wish to resolve this
> debate?
>
> Tom N4KG
>
> On Mon, 7 Oct 2002 Bill Coleman <aa4lr@arrl.net> writes:
> > On 10/7/02 8:53 AM, n4kg@juno.com at n4kg@juno.com wrote:
> >
> > >And what do you see as the problem?
> >
> > Since I sent this to you personally Tom, and you have answered on
> > the
> > list, I'll answer on the list.
> >
> > >The Legs are NOT rusted above the break at ground level,
> >
> > The rusting ground level is of grave concern.
> >
> > >The Legs are braced so they cannot move out or in,
> >
> > Are they? It is hard to tell from the description. What PE did the
> > calculations on the 3 foot pieces of angle iron pounded into the
> > ground?
> > Will they have sufficient strength to hold against all lateral
> > loads?
> > What happens over the next decade or so as they are subject to the
> > corrosive effects of the soil?
> >
> > >The space between ground and the next steps is filled
> > >with H braces at right angles to each other.
> >
> > Is the bracing sufficient to prevent twisting or lateral movement at
> > all
> > conceivable loads? Did a PE do the calculations? Are 2x6 PT boards
> > sufficient?
> >
> > Again, it is difficult to tell from the description, but it doesn't
> > sound
> > like conventional tower construction.
> >
> > >FYI, the tribanders were installed LONG AGO, before the
> > >legs rusted through at / just under the ground,
> >
> > Now THAT is a huge relief! From the way you originally posted the
> > message, it almost sounded the other way around.
> >
> > > AND, the
> > >tower has been climbed without incident in it's present
> > >condition.
> >
> > Again, this sounds like a good TEMPORARY solution for shoring the
> > tower
> > against a topple. It may even be sufficient to allow someone to
> > unstack
> > the tower so that it can be repaired. All things considered, it
> > would
> > likely be safer to use a crane and set the tower down before
> > repairing it.
> >
> > However, you presented this as a PERMANENT solution. I disagree. It
> > sounds unsafe.
> >
> > >Many people seem to fail to recognize that for a GUYED Tower,
> > >nearly ALL of the forces at the BASE are VERTICAL. The
> > >Horizontal forces on a Guyed Tower are carried by the GUY WIRES
> > >which converts them to additional vertical forces on the tower.
> >
> > Guys can only do their work of converting horizontal wind forces
> > into
> > vertical compression IF the base cannot move.
> >
> > Engineers design the towers with just this in mind. That's why bases
> > are
> > fixed laterally as well as vertically.
> >
> > >W1EVT has 19 R25 Towers 140 ft tall sitting on base plates
> > >supported by cinderblocks to place each base at the same elevation.
> > >There is NO lateral support at the base other than friction on
> > >the cinderblocks. These towers have been up for around 40 years
> > >that I know of.
> >
> > W1EVT is DAMNED lucky. (Although real cinder blocks would have
> > corroded
> > the base a LONG time ago, I assume he has them on concrete blocks --
> > in
> > which cases he is really lucky the base plates haven't cracked the
> > concrete blocks in all this time)
> >
> > >It is NOT necessary for a GUYED Tower to have
> > >a base rigidly attached to a large mass of concrete.
> >
> > Show me a PE-stamped tower design drawing that does NOT have the
> > base
> > anchored laterally as well as vertically.
> >
> > >It only needs a base that can support the Vertical Forces from the
> > tower.
> >
> > If that base moves too far, the tower will fall. Lateral anchoring
> > is
> > part of the design.
> >
> > You can show me 50 anecdotal stories of poor installations that have
> > not
> > fallen -- but it doesn't mean it is good practice. Just means people
> > were
> > lucky. So far.
> >
> > Sorry, I'm sticking to the LXC prime directive, and Rohn says
> > NOTHING
> > about concrete block bases or angle iron pounded into the ground.
> >
> >
> >
> > Bill Coleman, AA4LR, PP-ASEL Mail: aa4lr@arrl.net
> > Quote: "Not within a thousand years will man ever fly!"
> > -- Wilbur Wright, 1901
> >
> >
>
>
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today! For your FREE software, visit:
> http://dl.www.juno.com/get/web/.
> _______________________________________________
> AN Wireless Self Supporting Towers at discounted prices,
> See http://www.mscomputer.com
>
> Wireless Weather Stations now $349.95. Call Toll Free,
> 888-333-9041 for additional information.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
|