Get off your high horse. In a series circuit, which a loading
coil most certainly is, the current into and the current out of
a device must be the same. In the RF circuit, if the current
into and out of the coil is not the same only three things can
be happening:
1) there is radiation
2) there is loss
3) the measurement is disturbing the system being measured.
I suppose radiation is fine if one has a helical antenna (a
coil designed radiate) but that's not what the debate is about.
If you can't understand those concepts, go back to the very
first circuits (and E&M) courses.
ANY measured difference in I(in) vs. I(out) is either due to
one of those three effects and to argue otherwise is to argue
for perpetual motion.
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of K3BU@aol.com
> Sent: Friday, November 21, 2003 7:07 PM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Trap Resonance
>
>
> "One sided look" is based on real life measurements and
> reality. If that is smearing, then I am proud of it.
> I found on NG what I was looking for, confirmation and
> explanation what I have observed and knew, and W9UCW
> measured, it will be summarized, explained in a more
> comprehensive article after I will complete the work.
> Then we will see who is pathetic and who starts ridiculing
> those who do not agree with "guru's" erroneous "teachings."
> Stand by. How is that "proof" by Eznec using zero size coil?
> Go and MEASURE IT!
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|