Guys with ideas...
I am trying to remove a 3/4" aluminum element end from a swaged 1-1/4" element.
I don't think these have been apart in 30 years. What tricks do you guys have
up your sleeve to help me separate these two pieces of tubing?
Using vise grips on the smaller section I was able to rotate the element and
move it back about an inch, but that's as far as it has gone. I'll be chewing
up the smaller tubing if I continue this route.
I've soaked the connection with LPS lubricant overnight but thought I would put
out a call for ideas before giving it another go today...
TIA
73 de Bob - K0RC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|