Towertalk
[Top] [All Lists]

Re: [TowerTalk] Phillystran Guy Design

To: towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] Phillystran Guy Design
From: Steve Maki <steve@oakcom.com>
Date: Fri, 22 Dec 2006 11:13:05 -0500
List-post: <mailto:towertalk@contesting.com>
Dick Green WC1M wrote:

> K7LXC wrote:
> 
>>         There are also little  aluminum caps available that 
>> go over the end of the bottom grips (facing up the  guy). 
>> They are supposed to prevent ice that's sliding down the 
>> Phillystran from  unwinding the grips. I've seen tie wraps 
>> used for the same reason although they  could get ripped off 
>> in extreme ice conditions. 

> I received small open metal sleeves with the Rohn-supplied EHS Big Grips.
> I'm not sure what metal they're made of, but I think it's steel. I received
> black cable ties with the Phillystran guy grips. The metal sleeves jam down
> onto the end of the grip solidly and can't come off easily. It's very hard
> to tighten the cable ties on the Phillystran guy grips enough to keep them
> from sliding with only modest pressure. My impression is that they won't do
> a heck of a lot. On the other hand, it's hard to imagine enough ice sliding
> down the guy to open the end of the grip. Has anyone ever heard of that
> happening?
> 
> 73, Dick WC1M 

It's supposedly happened on some larger commercial towers, but I'm not 
sure where.

On my Philly guyed ham towers I carefully tape the ends (forming a cone) 
with good ole Scotch 33, which seems like it should be superior to cable 
ties.

Steve K8LX
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>