| To: | [email protected] |
|---|---|
| Subject: | Re: [TowerTalk] Thrust Bearing Screws & Fingers |
| From: | "Dan Zimmerman N3OX" <[email protected]> |
| Date: | Wed, 21 Feb 2007 13:38:35 -0500 |
| List-post: | <mailto:[email protected]> |
>Those bearing screws are only designed to hold the mast in the center of the bearing, not to keep it from slipping >down. Not if it's a real thrust bearing! It would surprise me if a manufacturer made a "thrust bearing" that couldn't take the rated vertical load with the supplied screws tightened properly. Dan _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Short (5') mast OK?, Dave Hachadorian |
|---|---|
| Next by Date: | Re: [TowerTalk] Thrust Bearing Screws & Fingers, AA6DX - Mark |
| Previous by Thread: | [TowerTalk] Thrust Bearing Screws & Fingers, Phil Camera |
| Next by Thread: | Re: [TowerTalk] Thrust Bearing Screws & Fingers, AA6DX - Mark |
| Indexes: | [Date] [Thread] [Top] [All Lists] |