Towertalk
[Top] [All Lists]

Re: [TowerTalk] pop riveters

To: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>,"Scott Millick" <smillick@wamusa.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] pop riveters
From: "mryan001" <mryan001@tampabay.rr.com>
Date: Sun, 22 Apr 2007 00:17:15 -0400
List-post: <mailto:towertalk@contesting.com>
Also just for informational purposes.....keep in mind that the type of
rivets used by FORCE 12 for their antennas is not a common rivet. They sell
them if you need replacements but they are not so common that you can walk
into a Home Depot and buy them.  -Mike

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Roger (K8RI)
Sent: Sunday, April 22, 2007 12:05 AM
To: Scott Millick; towertalk@contesting.com
Subject: Re: [TowerTalk] pop riveters


Don't forget to make sure the pop rivett shaknks and gun fit each other.
OTOH a good mechanical gun should make  the standard Aluminum and Stainless
Steel rivetts almost effortless.

Roger (K8RI)

> Does anyone know where to get a air powered pop riveter as looked at
> Lowes and there was none there   I have a couple of Force 12 to put
> up and the hand gets real sore after a while as I have a problem with a
> tendon
>
> Scotty K9SM
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>