Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mast slipping

To: towertalk@contesting.com, kdutson@sbcglobal.net
Subject: Re: [TowerTalk] Mast slipping
From: K7LXC@aol.com
Date: Mon, 23 Apr 2007 08:05:23 EDT
List-post: <mailto:towertalk@contesting.com>
 
In a message dated 4/22/2007 7:11:18 P.M. Pacific Daylight Time,  
towertalk-request@contesting.com writes:

>  Frank,

>  Are you saying the Orion has a  basic design flaw that no amount of
strengthening or improvement will  correct?  If so, please elaborate.


         Did you miss my  recent 4-20 Orion post where I spelled out exactly 
what the design flaws were?  Here it is again:
 
>      It's an Orion design flaw, the mast  clamp has 2  problems. First, the 
surface where the nuts and bolts seat  are dimpled - not  flat. Over time, 
the 
wind motion causes the washers  to pound the dimples flat,  thus loosening up 
the 
nuts; then the  mast is loose and starts moving. The  problem can be 
eliminated 
by  milling or grinding those surfaces flat. 

>    Secondly only 2-3 teeth per surface of the clamp actually  contact the  
mast, 
resulting in very little clamping. Then you get the teeth  being  worn down 
as 
the mast moves back and forth and it loosens some more.   

>  You can re-tighten everything and it'll probably  be  good for a couple of 
years. For a 4L SteppIR, you can also pin the  mast.  Pinning works for 
everything except a MonstIR which tends to  shear them off.
 
Cheers,
Steve   K7LXC
TOWER TECH  




************************************** See what's free at http://www.aol.com.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>