Towertalk
[Top] [All Lists]

Re: [TowerTalk] US TowerHDX-555

To: "Junior" <charlesw_anders@bellsouth.net>,towertalk@contesting.com
Subject: Re: [TowerTalk] US TowerHDX-555
From: steve.root@culligan4water.com
Date: Sat, 14 Jul 2007 22:31:47 +0000
List-post: <mailto:towertalk@contesting.com>
I think I have essentially the same tower. Mine doesn't have "positive pull 
down"; that's another cable that will telescope the tower sections back 
together. If I have the tower horizontal for maintenance and crank the top 
section out, i have to push mine back in manually. When it's vertically 
positioned gravity will do the job for you.
Without positive pull down, you have to be careful that the tower sections 
aren't binding when you try to retract the tower. That can happen when the wind 
is blowing strong.
73 Steve K0SR


>-----Original Message-----
>From: Junior [mailto:charlesw_anders@bellsouth.net]
>Sent: Saturday, July 14, 2007 11:11 AM
>To: towertalk@contesting.com
>Subject: [TowerTalk] US TowerHDX-555
>
>Hello All,
>
>I just completed putting the rotator on the tower.
>
>The tower is in a horizontal position and I cranked the inner tower out
>approx 4ft for easy access to install the rotator per the instructions.
>
> 
>
>When I go to crank (retract) the 4ft all I get is loose cable off the crank
>reel. I can push the 4ft back into the tower just fine
>
>and it tightens up the loose cable. 
>
>( Tower cranks out(up) just fine).
>
> 
>
>My question is if I crank the tower all the way up(with antenna mounted)
>once I get it into the vertical position and I go to crank
>
>it back down am I going to get loose cable and the tower starts to
>"freefall" back down?
>
> 
>
>The instructions indicate you should be able to retract (the 4ft) tower
>without cranking it to 55ft first then crank backdown.
>
>But it appears that comment is if the tower was already in the vertical
>position and you mounted the rotator with it in the vertical position.
>Nothing in the instructions on trouble shooting to much.
>
>Is it a gravity thing when you start cranking(retracting) the tower to it's
>nested position.
>
>US Tower is closed today.
>
>I would appreciate it if you could reply direct also. For some reason I
>don't get all the list posted messages on the various list servers.
>
>Thanks
>
>Charles 
>
> 
>
> 
>
> 
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>