Towertalk
[Top] [All Lists]

Re: [TowerTalk] Coper clad steel

To: <K2EK@aol.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Coper clad steel
From: "K8RI" <K8RI-on-TowerTalk@tm.net>
Date: Mon, 24 Sep 2007 21:22:41 -0400
List-post: <mailto:towertalk@contesting.com>


> DON'T  !!!!
>
> I made 2 BIG mistakes a while back in ENY...  the first was using Sears
> Aluminum electric fence wire....  It turned to a white powder after a few 
> years.
> The 2nd was using galvanized fence wire...  Also cheap...  It turned to 
> rust.
> In fact, The "copperweld" fence wire I used for beverages also rusted out 
> and
> was nearly impossible to solder repair the inevitable fixes...


I use "CopperWeld" antenna wire for...antennas, but once the antenna is up 
and tuned that's it.  After its been up a few weeks you'll never get solder 
to stick to it again.  I use the material for strength. The copper plate is 
so thin its difficult if not impossible to polish it to the point of being 
able to solder as its bare steel before you get that far. Maybe in the "old 
days" they had a thicker coat, I don't know. However if the stuff 
deteoriates that fast in air, I'd sure not want to put it in the ground.

73

Roger (K8RI)

>
> Considering the work / hassle....  Do yourself a favor.  Get the 1000' 
> spools
> of solid copper radial wire from Craig at radiobooks.com... (or else where 
> if
> you can locate it)
>
> I'm nearly done installing the first 3000 feet here ...  Another 3000 on 
> this
> tower yet to go...
>
> 73 de Bill
> K2EK
>
>
>
>
>
> ************************************** See what's new at 
> http://www.aol.com
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>