Towertalk
[Top] [All Lists]

Re: [TowerTalk] Polyphaser Questions

To: "Gary Schafer" <garyschafer@comcast.net>,"'RICHARD SOLOMON'" <w1ksz@q.com>,"'TowerTalk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Polyphaser Questions
From: Bill Winkis <kc4pe@mindspring.com>
Date: Fri, 02 Nov 2007 07:08:41 -0400
List-post: <mailto:towertalk@contesting.com>
If you go to my "Shack Web Site", you will see in part what Gary is 
talking about ....
I dope ground rods and the whole bit.

The site is large so give it a minute to load...

http://www.kc4pe.com/pix.htm

Enjoy..!!

-Bill
kc4pe@bellsouth.net



At 01:21 PM 11/1/2007, Gary Schafer wrote:

>You should mount them on a plate at the shack entrance and not at the tower.
>Do ground the shields of the coax to the tower at the base of the tower. Use
>a copper or aluminum plate to mount all your suppressors on (a common plate)
>and ground that well. The plate should be near ground level outside your
>shack so you have a very short ground lead to your earth ground. That ground
>lead ideally should be wide copper strap and no more than 4 to 6 feet to
>your first ground rod. For an adequate ground you should have several ground
>rods connected by buried radials running out away from the house. Polyphaser
>tells you how to do this too.
>
>73
>Gary  K4FMX
>
> > -----Original Message-----
> > From: towertalk-bounces@contesting.com [mailto:towertalk-
> > bounces@contesting.com] On Behalf Of RICHARD SOLOMON
> > Sent: Thursday, November 01, 2007 12:13 PM
> > To: TowerTalk
> > Subject: [TowerTalk] Polyphaser Questions
> >
> > Is there a distributor for Polyphaser or does one buy direct ?
> >
> > What is the best way to mount them ? I didn't find any mounting info on
> > the
> > Polyphaser website. I think a flat plate bolted to the tower legs with U-
> > Bolts ??
> > or what ?
> > The shack is about 80' from the tower. My plan is to install a set of
> > Polyphasers
> > at the tower and run the Coax and Rotor Control cable through conduit
> > under-
> > ground (12" or so). Would it add any value to have another set of
> > Polyphasers
> > at the shack entrance ?
> >
> > Thanks for any help,
> >
> > 73, Dick, W1KSZ/7
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>