The Portalign is an interesting fixture. Too bad the company went out of
business years (30 +/- ?)
ago. Anyone have one they want to sell ??
73, Dick, W1KSZ/7
ject: [TowerTalk] Drilling tubing (180 deg)> > Using my previous paper for
marking a cut line, remove paper from tubing ande flatten it out making a
crease in the paper. Each crease is 180 degrees from the other. result a NO
measurement method of finding opposing holes for drill in round stock material.
Just slide the pper back over the tubing and mark the tubing at the crease. All
this takes is paper, some Scotch tape, and a pencil.> > For small tubing a
"PORTA-LIGN fixture on a hand drill will provide a good thru hole. Used this
method to make 4X14el 2M yagis and 8X16el 432MHz yagis.> > Arne N7KA>
_______________________________________________> > > >
_______________________________________________> TowerTalk mailing list>
TowerTalk@contesting.com> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|