Dan, I have had good success splicing booms by using inside tubing which has
been slit lengthwise. I use a piece of the boom material, squeeze it
together and drive it into the ID with a wood block and hammer. The slit
will have to be 1/4 inch wide or so. You could even slide a second piece
inside that for more strength. A couple of sheet metal screws will hold
everything together.
73, Dan, N5AR
-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Dan Zimmerman N3OX
Sent: Sunday, January 13, 2008 9:59 AM
To: [email protected]
Subject: [TowerTalk] Aluminum tubing over 2"
Looking for a 6 foot stick of 2.25" O.D. 1/8th wall aluminum tubing to
make some couplers for a guyed rotating mast of 2" tubing.
I'm having a hard time finding it for non-ridiculous prices. Haven't
found anything much under $9/foot and that's pre-shipping.
Anyone have a supplier they like that will sell in small quantities
without big handling fees?
Or am I just off base here and it just costs $8-$9 per foot for 2.25"
x 0.125" 6061-T6 or equivalent tubing? Is it just a weird size?
73
Dan
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|