I couldnt find them anywhere so I made them from 6 pin cinch-jones plugs.
Just heat the blades up a bit and twist the 2 blades 90 degrees.
Pete K4OM
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Artmouton
Sent: Thursday, May 08, 2008 8:15 AM
To: Pstark; towertalk@contesting.com
Subject: Re: [TowerTalk] Plug for Yaesu Rotor Control Box
it is rectangular in shape with 4 horizontal poles and 2 vertical (really
look like "+"'s
Art K5FNQ
----- Original Message -----
From: "Pstark" <pstark@suddenlink.net>
To: "Artmouton" <k5fnq@cox.net>; <towertalk@contesting.com>
Sent: Thursday, May 08, 2008 6:51 AM
Subject: RE: [TowerTalk] Plug for Yaesu Rotor Control Box
> Is that the Molex-like plug or the Cinch-Jones Like plug?
>
> Pete K4OM
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com]On Behalf Of Artmouton
> Sent: Thursday, May 08, 2008 7:30 AM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Plug for Yaesu Rotor Control Box
>
>
> I am in need of the 6 line plug for the back of the Yaesu SDX1000 Rotor
> Control box - any ideas of source?
> K5FNQ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|