Same done here. Works great. They stick down a bit but who cares.
73 Dave n4zkf
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Roger (K8RI)
Sent: Friday, June 06, 2008 4:05 PM
To: [email protected]
Cc: [email protected]; 'Towertalk'; [email protected]; 'Barry Merrill'
Subject: Re: [TowerTalk] Hindsight: Check your rotator bolts
Dick Green WC1M wrote:
> How do you get double nuts on a bolt that has no nuts to begin with?
> The bolts screw into threads in the rotor casing. There's no way to
> double nut them.
>
>
Sho nuff is. I use longer bolts, put nuts and lock washers on the extended
threads, screw the bolt in the proper distance and then tighten the nut
against the base. Pretty it's not, effective it is. <:-))
> 73, Dick WC1M
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|