Hi Art,
I'll add my idea to the other good ideas listed, sometimes it's good to have
options, they might inspire better methods!
Please check the link below, go about 3/4 down the page.
http://www.wa9wsj.com/antenna_page.htm
Although I have a Rohn 25G tower, the stainless steel U-bolt method will
certainly work with the right size clamps for any round leg tower. Instead of a
copper backing bar, as I used, you could use aluminum or steel etc. Just need
something so the flat clamp that comes with the u-bolt doesn't bend when you
tighten it down, you'll get the idea when you see the pic.
73
Tom
--- On Sun, 8/17/08, Artmouton <k5fnq@cox.net> wrote:
> From: Artmouton <k5fnq@cox.net>
> Subject: [TowerTalk] Connection Tower to ground rods
> To: towertalk@contesting.com
> Date: Sunday, August 17, 2008, 12:10 PM
> I have hammered in two 8' copper ground rods.
> Will probably do two more later - they ain't cheap and
> not easy (although we
> are all dirt and gumbo mud here in South Louisiana.
>
> I now need to attach them to tower base.
>
> I have some coax type shield or some very large wire.
> Which one would be best?
>
> Then how to connect to ground rod - dissimilar metal
> connector?
>
> How to connect to tower - Rohn 55G.
> Prior owner had painted it.
> I will brush off paint area at connection point but do not
> want to destroy
> the coating - so how deep and how to connect to the tower
> leg?
> Tnx & 73,
> Art K5FNQ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|