I'm not sure that I see the advantage to this, unless both towers are near
each other and very far from the shack. If you connect the motors
together so that both turn at the same time, you will need larger wires and
you would only be able to use the indicator from one rotator so the
direction of the second would be out of sync. You could install relays
outside that would switch between the rotators and use a common cable and
controller, but then you would need to run extra wires for the relays.
John KK9A
Subject: [TowerTalk] 1 control box on more than 1 rotor
From: [email protected]
Date: Thu, 15 Jan 2009 21:02:03 EST
I am going to stick a couple more towers in the air and wondering if anyone
has tried or done the below .
i would like to operate 2 or more rotors with one control box. They will
al
be TX2 style rotors. I just would like to save some on running all the
rotor
cable to each tower .
It is just a idea....
Thanks Randy
Carlus M. Randy Chavis
WB4UNA since 1970
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|