You can buy a "chinese handcuff" widget at Home Depot. It's in the
electrical department, with the tools for fishing cables through
existing walls. It has a snap hook on the end; buy two and clip them
together.
- Dennis, N1DB
On Sep 19, 2009, at 12:33 PM, David Gilbert wrote:
>
> Remember those "Chinese handcuffs" we used to put over a finger on
> each
> hand that grip when you pull apart? You should be able to make one
> out
> of the braid from some RG-8 coax. Slip it over it the ends of the two
> ropes and pull tightly to grip both ropes, then haul away.
>
> 73,
> Dave AB7E
>
>
>
>
> Pete Smith wrote:
>> I want to replace the up-haul ropes that support my 80M array. To do
>> that, I need to find a way to thread the new rope through small
>> pulleys
>> at the 95-foot level on my tower. If possible, I'd like to do it
>> without climbing all the way up there. I could simply tie the new
>> rope
>> to the old one, but I'm concerned that any knot might be too big to
>> make
>> it through the pulley.
>>
>> I've been thinking about mixing up a little two part epoxy and
>> literally
>> gluing the new rope to the old, end-to-end. Has anyone out there
>> done
>> that, and if so, how did it work? If you have a better way, please
>> let
>> me know.
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|