Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotator Mounting Dimensions

To: "'Larry Banks'" <larryb.w1dyj@verizon.net>, "'Tower Talk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rotator Mounting Dimensions
From: Bert Almemo <balmemo@sympatico.ca>
Date: Wed, 1 Aug 2012 22:21:26 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Sorry guys. The file was supposed to go to Larry only.

73 Bert, VE3NR

 

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Larry Banks
Sent: Wednesday, August 01, 2012 9:30 PM
To: Tower Talk
Subject: [TowerTalk] Rotator Mounting Dimensions

Hi TT'ers

I am designing a base plate for mounting an old TR-44 rotator and cannot
find dimensions anywhere on the Internet.  I measure 3" c-to-c from the
rotator on my workbench.   Is this the correct dimension?  What size hole?
Is this the same for modern Hy Gain rotators too?

(Since I may purchase a new rotator in the future if this one fails, I am
also going to add holes for Yaesu rotators -- at least I know that the
correct dimension there is 84mm for all of them.)

73 -- Larry -- W1DYJ


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>