Towertalk
[Top] [All Lists]

[TowerTalk] Aligning rotor, mast and thrust bearing

To: <towertalk@contesting.com>
Subject: [TowerTalk] Aligning rotor, mast and thrust bearing
From: "Rick Kiessig" <kiessig@gmail.com>
Date: Fri, 5 Oct 2012 23:11:27 +1300
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
My new tower project is moving ahead nicely. All major parts have arrived,
including the tower itself (a custom 8.5m x 0.2m diam galvanized pole). Now
it's just a matter of finishing the construction and installation.

 

I've been working on aligning the rotor (PST61), mast and thrust bearing
(TB3). I was thinking about bolting everything to the tower before they
crane it into place (suggested by the installer). However, I'm finding it to
be a challenge to align things correctly, particularly with the tower laying
down at an angle - too many degrees of freedom.

 

I suppose I could just wait until the tower is vertical, but even then it
seems like it won't be easy (since it was a custom build, I would also like
to confirm that the bolt holes for the rotor plate and the thrust bearing
line up correctly). If anyone has any suggestions / tips along these lines,
I would love to hear them.

 

73, Rick ZL2HAM (ZL1G/ZM1G)

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>