Any one have any quality photographs of the shaft failure? I am looking at
photographs of the fracture surface. That should tell us the mechanism of
failure.
Scott
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
KJ6Y@aol.com
Sent: Saturday, October 13, 2012 1:37 PM
To: dino@kx6d.com; towertalk@contesting.com
Subject: Re: [TowerTalk] Yet another worm gear box failure...
Mike's tower sounds like the shaft broke and not a gearbox failure. On
the older MD-750 motor drives, the shaft was 1 inch coming out of the
gearbox. (Tristao and then US Tower). US Tower then went to a larger
shaft, 1 1/4 or 1 1/2, don't remember which. Have not seen any of the
newer ones fail.
There is a lot of tension on that multi groove pulley, especially when
hams have a tendency to overload their tower. It's not just wind load but
weight. Those towers have a weight limit. Add it all up, mast, rotor,
antennas, cables, etc and I'm sure you'll see more weight then you thought.
Regular maintenance and inspections should be done.
Skip, _KJ6Y_ (http://www.kj6y.com/)
_Communications Service Co_ (http://www.communicationsserviceco.com/)
818-887-3569
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|