I am planning a 160m vertical with elevated radials, using Rohn 25G tower
sections. I plan to have the tower insulated at 30' above ground.
Rohn is very proud of their 25TG insulated section and I have heartburn paying
over $2K for the section, so I am looking for alternatives to insulate this
tower. There will be 130' of tower above the insulated part.
Someone recommended using fiberglass rod machined down to fit inside the 3 legs
and I am currently investigating this option.
Any other ideas / comments / recommendations would be greatly appreciated.
73's
NJ0F
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|