Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower regulations for home brew towers in the US?

To: "Roger (K8RI) on TT" <k8ri-on-towertalk@tm.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Tower regulations for home brew towers in the US?
From: Markku Oksanen <markku.a.oksanen@kolumbus.fi>
Date: Sat, 22 Feb 2014 16:26:20 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
ALL
I would conclude that firstA) Rural areas on a large piece of property the 
county might not interfere much, perhaps a building permit but nothing elseB) 
Closer to civilization things get progressively harder with regulations, 
neighbors etc.  County might just not give you any permit at all.C) It may be 
best to ask the county offices before relocating with a bunch of aluminium
Liability is an other question:  If you have your home made towers A) Is it a 
good idea to put a fence around the whole thing, guy wires and all, and put 
warning signs so that everybody would know that there is perhaps ice aboveB) Is 
it necessary to prevent anybody from climbing a tower with those anti climbing 
boards on the bottom of the tower or is high fencing enough?C) How about 
verticals with high RF voltage? Fence around or what?
Insurance:  Can you insure your tower against forces or nature?  
Thanks!
Markku

> Date: Fri, 21 Feb 2014 17:54:01 -0500
> From: K8RI-on-TowerTalk@tm.net
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Tower regulations for home brew towers in the US?
> 
> On 2/21/2014 5:24 AM, Markku Oksanen wrote:
> > All
> > Just because I am curious:
> > Here at OH-land even large towers can be home brew just like my 160 and 145 
> > foot rotating towers.These have been made by a private small company that 
> > made perhaps 200 towers through the years.Building permit and zoning never 
> > questioned the "engineering" of the towers as the responsibility in the end 
> > rests with the owner.In addition, home owner insurance happily includes 
> > towers and covers damage without question.
> 
> As others have said, there is no national standard "except" above 200 
> feet it requires FAA permission and lighting. There are also height 
> limitations based on being close to an airport.
> 
> I live just to the West of Midland MI in Homer Township.  They have no 
> limitations on ham towers "except" for "set back"  IOW, if the tower 
> falls it must fall on your property.  That is tower only. I had 30' of 
> mast with a large array on it above the tower..
> http://www.rogerhalstead.com/ham_files/Tower29.htm
> The top of the tower just met the "set back".  They did not care what 
> was on the top. I needed the height for exposure limits.  As I'm right 
> on the centerline for the GPS 06 approach for Midland Barstow Airport 
> (KIKW) the FAA  rules apply, but I'm a tad over 4 miles out and just 
> inside the final approach fix (FAF). Sooo... I can go to about 190 feet. 
> On my one square acre lot that would be impractical.
> 
> When they were rezoning, I maintained close contact with the committee 
> with the result that they exempted regulations on Ham towers because of 
> FAA and FCC regs were deemed sufficient. So here I can build my own 
> tower, be it guyed, self supporting, or crank up/tilt over.
> 
> 73
> 
> Roger (K8RI)
> 
> > How is the situation in the US?  Looks like most towers are commercial 
> > (Rohn, couple others) and it seems that a "professional engineer" 
> > (correct??) needs to look at the mechanics of the whole thing in order to 
> > get a permit to put up a tower.
> > So, how, if at all, is it possible to build your own large towers?  Does 
> > anybody do this?
> > The towers I have are 1.5 feet a side with 2 inch tubes, inverted U (0.7 
> > inch) "cross bars".  Only guyed at two levels and full of aluminium, 8000 
> > lb steel guy wires and ball bearing guy rings.  And they have survived some 
> > crazy storm too in the past 15 years.
> > MarkkuOH2RA/OG2A/WW1C                                       
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
                                          
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>