> I'm going to be using Phillystran Cable .22 size and am not able to use
the "Big Grip" on a couple of the ends & was wondering if a standard
"guy wire clamp" can be used and what is the recommended configuration?
It appears that DX Engr. recommends that guy wire clamps only be used on
.17 and smaller.
Yes, only on the smaller sizes since there's no Big Grip for them. The
factory does not recommend using cable clamps since over time the aramid
fibers will cold flow and reduce the strength of the Phillystran.
What's the reason why you can't use the Big Grips "on a couple of
ends"?
Cheers,
Steve K7LXC
TOWER TECH
Cell: 206-890-4188
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|