As a WISP owner, I will not speak for your WISP, but all of our antennas
are less than 2 sq ft wind load. Most weigh less than 5 lbs, so a little
more than some TV antennas.
On 7/1/2014 9:24 PM, Linux Mercedes wrote:
Wayne,
I'll primarily be using it for wireless internet. Unfortunately, the
tech at the WISP I spoke to was pretty vague about the wind load of
the antenna they'll be using, but he assured me it would be 'minimal'
and didn't think it would be that big of a concern.
I won't be house bracketing this install, but it will be guyed at two
levels (what Rohn recommends for 50' of 25G).
--Nathan
On 07/01/2014 09:59 AM, Wayne Kline wrote:
I also have experience with 20-G and 25-G towers... @ my station my
2mter/450 MHZ and one 6 meter beam
5 element 14' boom are on at 36ft. an consist of 3 sections of
20-G and a top of 25-G AG3 ? it's house bracketed @ 18 ft.
Been in place for 24 years BUT extremely light wind load.
IMHO @ HF a C-3. TA33 or A3 would be the BIGGEST .
So my question to you is WHAT are you planning to adorn the tower with ?
Wayne W3EA . .
Date: Tue, 1 Jul 2014 07:42:14 -0500
From: kkbroadcastengineering@gmail.com
CC: towertalk@contesting.com
Subject: Re: [TowerTalk] Mixing Rohn 20G and 25G
Nathan,
I would caution you to not mix the sections nor even use the 20 for
anything more than VERY light duty use.
With that said... Back in my younger days when I did a lot of tower
work
for CB and Ham operators, there were a number of mixed 20/25 towers
supporting large CB antennas and they stayed up many years. I do
recall
working on one where the 20 top section physically broke during a wind
storm.
Climbing a mixed 20/25 tower is a real pain as the steps are different
distances apart.
Good luck,
Kevin C. Kidd, CSRE/AMD
AM Ground Systems Company - WD4RAT
kkidd@kkbc.com -- 866-22-RADIO -- 866-227-2346
www.amgroundsystems.com
On Mon, Jun 30, 2014 at 7:42 PM, Linux Mercedes
<linuxmercedes@gmail.com>
wrote:
Hello,
Whilst moving tower sections from the shed to the shop so I could
clean
them up and make a couple of fixes before putting up my tower, I
noticed
that some of them seemed lighter than others. Turns out I've got a
mix of
20G and 25G sections.
What are your thoughts on putting up, say, 30 or 40 feet of 25G and
then
another 20 or 10 feet of 20G? I'd like to use the best sections I
have on
the tower, but if mixing is a no, then I'll fix up some of the other
sections I have and build a homogeneous tower.
Thanks,
Nathan
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Scott Reed
Owner
NewWays Networking, LLC
Wireless Networking
Network Design, Installation and Administration
Mikrotik Advanced Certified
www.nwwnet.net
(765) 855-1060 (765) 439-4253 Toll-free (855) 231-6239
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|