Towertalk
[Top] [All Lists]

[TowerTalk] Trap ID

To: <towertalk@contesting.com>
Subject: [TowerTalk] Trap ID
From: W1JCW <w1jcw@hotmail.com>
Date: Wed, 10 Dec 2014 08:23:00 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Well stated Matt..

I have owned Mosley antennas since I was 11 now 47, they are good antennas and 
I have learned what you have stated over the years. 

Of course Mosley is a good source, Gary Jr and Sr are always very helpful. 

73-
W1JCW
John

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Matt
Sent: Tuesday, December 09, 2014 10:24 PM
To: towertalk@contesting.com
Subject: [TowerTalk] FW: Trap ID

Mosley TA33 trap explanation:

To the best of my knowledge, this is how it works...

Inside the trap there are coils on each end.   The inner element inserts into 
coil form such that the aluminum trap cover forms a coaxial capacitor along 
their overlapping length.  This is wired in parallel with the inner coil to 
form a resonant trap for the 10m band.   On 15m, the 10m trap becomes a net 
lump-sum inductance, thereby shortening the resonant length of the 15m section. 
  The length of the aluminum trap cover is cut to resonant the antenna on 15m.  
 The outboard element tip inserts into the other end of the coil form such that 
the aluminum trap cover also forms a coaxial capacitor along their overlapping 
length.  This is also wired in parallel with the outer coal to form the 15m 
resonant trap.   On 20m, both the 10m trap and the 15m trap both become net 
lump-sum inductances which shorten the resonant length of the 20m section.   
The outer element length is then selected to be resonant on the 20m band.

Stuff that can go wrong with the traps:  

1. Coil form cracks and arcs over to the inner element at high voltages (high 
power).  Be aware that the coil form is also a structural part of the element - 
it transfer bending moments from wind loadings or other forces acting on the 
outer element tip.
2. RF contact quality where the end of the coil connects to the outer trap 
cover degrades (usually from oxidation - keep it clean and apply some penetrox 
or similar at the connection).
3. Overheating the coil melts the coil form and physically changes the shape of 
the coil enough to move the resonance.
4. Coil wire open circuits at the end where it is riveted to the inner element.
5.  Insects, or their residue, become moist with humidity (or infiltrated rain) 
and short out sections of coil winding, changing the resonance.
6. And my favorite...   the element is mounted upside down such that the trap 
drains are at the top....  the trap fills up with rain water and....  

BTW, the traps for TA-series are different for each element.   They can be 
identified (director, driver, reflector) by counting the number of turns on the 
coils.

Hope this is helpful and good luck on your project.

73
Matt
KM5VI


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>