Towertalk
[Top] [All Lists]

Re: [TowerTalk] FW: Concrete Pad for U.S. Tower TX-472

To: ve4xt@mymts.net
Subject: Re: [TowerTalk] FW: Concrete Pad for U.S. Tower TX-472
From: Patrick Greenlee <patrick_g@windstream.net>
Date: Mon, 27 Jul 2015 09:48:19 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
No worries, mate. Concrete boat ramps are poured underwater. I have pored foundations etc with water in them. The concrete displaces the water without becoming diluted.

Patrick      NJ5G

On 7/26/2015 3:09 PM, ve4xt@mymts.net wrote:
I hope to pour in August, but I too have water. If it's only a few inches, is 
it worth worrying about?

73, Kelly
ve4xt

Sent from my iPhone

On Jul 26, 2015, at 13:31, "Patrick Greenlee" <patrick_g@windstream.net> wrote:

My next tower install is coming late this summer or early fall (depending on 
when the tower is built/shipped.  I fully expect the hole 4x4x8 ft to at least 
partially fill up from ground water if I don't take precautions.  Even during 
the recent record setting drought I had ground water within 5 ft of the surface 
but this is NOT a drought year.

Boat launching ramps are poured into forms fully submerged as concrete easily displaces 
the water without being "watered down." My concern is that the walls of the 
hole, if significantly soaked, may collapse. So I may put a sump pump in the hole with a 
float switch to keep the water pumped down to a couple inches.  I'll build a little 
cubical wood frame and cover it with geotextile to filter out solids and not let the pump 
clog.

Patrick     NJ5G

On 7/25/2015 11:14 PM, Roger (K8RI) on TT wrote:
I had no problem keeping it wet.  The spring water table was just a couple 
inches below the surface. We kept a sump pump running until the concrete was 
being poured into the hole.   It was a good dry mix relatively speaking, yet 
when the concrete reached the top, it was pushing out water.

As I was breaking up the over flow a couple weeks later, someone asked, "Wouldn't it be 
easier to just paint it green?"  The dirt under the hardened overflow was still soggy.  
So other than sprinkling the surface, keeping it wet was not a problem<:-)

73

Roger (K8RI)
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>