Towertalk
[Top] [All Lists]

Re: [TowerTalk] LMR-600 end connector, M or F ?

To: Paul Christensen <w9ac@arrl.net>
Subject: Re: [TowerTalk] LMR-600 end connector, M or F ?
From: mike stokes <mike9v@gmail.com>
Date: Wed, 5 Aug 2015 21:07:14 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Where is the best place to buy good N female barrels ?

Mike
KK9V

On Wed, Aug 5, 2015 at 8:35 PM, Paul Christensen <w9ac@arrl.net> wrote:

> What do you prefer for your LMR-600 end connectors, female or male or does
>> it make any difference?
>>
>
> N4CC and I recently used male N connectors on both ends of the LMR-600
> runs. The copper bulkhead we use for our external ground bus is loaded with
> Polyphaser and Transitrap devices that come with female connectors on both
> sides.  So, in our case, it was kind of a no-brainer to use male connectors
> on the shack end of the LMR-600 runs.
>
> On the antenna end, we also used male N connectors with N female barrels
> that join short lengths of RG-213 to the antenna feeds.  This facilitates
> VNA measurements looking into either direction of the cable without having
> to hunt down a gender-change jumper cable or adapter in mid air.   The
> barrel is just broken apart for measurements into either the source or load
> end of the line.
>
> Paul, W9AC
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



-- 
Mike Stokes
KK9V
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>