Bert,
Very interesting idea. Try it! I guess you should stack a couple of different
toroides on top of each other and check it on an analyser. Please let us know
your result.
Hans - N2JFS
-----Original Message-----
From: Bert Almemo <[email protected]>
To: 'Grant Saviers' <[email protected]>; 'Kelly Taylor' <[email protected]>;
'Patrick Greenlee' <[email protected]>
Cc: towertalk <[email protected]>
Sent: Fri, Apr 8, 2016 2:36 pm
Subject: Re: [TowerTalk] [Bulk] Re: BALUN revisited again
As I was reading the post I was wondering if you could use ferrites of
different mix in the same choke/balun? Would that work or not? I've read
Jim's/K9YC excellent paper on chokes and baluns, but I couldn't find any
mentioning about different material in the same choke. Just curious.
73 Bert, VE3NR
-----Original Message-----
From: TowerTalk [mailto:[email protected]] On Behalf Of Grant
Saviers
Sent: Friday, April 08, 2016 9:59 AM
To: Kelly Taylor; Patrick Greenlee
Cc: [email protected]
Subject: Re: [TowerTalk] [Bulk] Re: BALUN revisited again
It is difficult to make a single choke for 40 to 6m but it is easy to
put two in series on the feedline. The K9YC tutorial has designs for 40
to 10m and 6m. I like using multiple type 43 or 31 small clamp ons for
VHF, see the appendix for the recommendations.
Also, G3TXQ has a nice summary chart for chokes at
http://www.karinya.net/g3txq/chokes/
Grant KZ1W
On 4/7/2016 12:18 PM, Kelly Taylor wrote:
> Hi Patrick
>
> The benefits of a choke go beyond what happens on TX. A choke can also cut
down RX noise.
>
> If you read k9yc's material, you'll see a choke does not need to be
complicated or expensive. Using his data, I made one that was nothing more
than 8 turns through a Biggest Clamp-on.
>
> As well, your contact's suggestion ignores the fact most antennas that
need chokes already have feedlines departing at 90 degrees.
>
> 73, kelly, ve4xt
>
> Sent from my iPhone
>
>> On Apr 7, 2016, at 1:50 PM, Patrick Greenlee <[email protected]>
wrote:
>>
>> Thanks every one for your replies. I was misinformed, the adjustable
elements are just a tad over 17 feet when extended.
>>
>> I did get one suggestion from a contact in Colorado who said if the
feedline comes well away from the antenna on the midline at right angles to
the antenna just hook it up sans chokes or baluns and go for it, especially
on QRP.
>>
>> Good info. You guys have covered all areas.
>>
>> Thanks everyone.
>>
>>
>> Patrick NJ5G
>>
>>> On 4/7/2016 1:07 PM, Jim Brown wrote:
>>> Yes.
>>>
>>> 73, Jim
>>>
>>>> On Thu,4/7/2016 9:54 AM, TexasRF--- via TowerTalk wrote:
>>>> Great answer but applies to a different question. Perhaps to the
original
>>>> posting that you deleted?
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> [email protected]
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> [email protected]
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|