| To: | "towertalk@contesting.com" <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] Lifting a mast off the rotator |
| From: | N5KM - Kris <n5kilomike@gmail.com> |
| Date: | Mon, 25 Apr 2016 10:09:23 -0500 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I use a small automotive hydraulic jack. Place the jack under the rotator. Loosen the mast thrust bearing(s) and rotator shelf u-bolts. Jack everything up the required amount then tighten the thrust bearing(s). Lower the jack. The centering block is now accessible. Do the above in reverse order to put everything back. Kris N5KM _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Rotor load bearing weight, Patrick Greenlee |
|---|---|
| Next by Date: | Re: [TowerTalk] [Bulk] Lifting a mast off the rotator, Bob K6UJ |
| Previous by Thread: | Re: [TowerTalk] [Bulk] Lifting a mast off the rotator, Les Kalmus |
| Next by Thread: | Re: [TowerTalk] Lifting a mast off the rotator, Chuck Dietz |
| Indexes: | [Date] [Thread] [Top] [All Lists] |