Laying on the ground, "stapled" down to the earth as needed with the
ends poked in the ground by a tool and hammer.
On Wed, 25 May 2016 21:50:31 -0700 Bob K6UJ <k6uj@pacbell.net> writes:
> Charlie,
>
> Are these radials going to be elevated with the ends anchored to the
>
> ground ?
>
> Bob
> K6Uj
>
> On 5/25/16 9:11 PM, n0tt1@juno.com wrote:
> > Hi Gents,
> >
> > I'm planning to use single strands (i.e. half a pair) of the
> > 2-conductor Military Surplus "WD-1a" wire for a lot of radials.
> >
> > I know that there are 3 steel stands and 4 copper strands
> > in each conductor. Obviously, it is "mandatory" to keep
> > water from wicking inside the insulation and doing some
> > real damage!!
> >
> > My question is "what works" or what "has worked" for
> > you to seal the cut wire ends? I would need something
> > that's not going to pull off or rub off because I plan on
> > anchoring the wire ends to the ground with a tool and hammer.
> >
> > Some ideas here...Maybe crimp-on end caps with some
> > silicone or grease inside? "Flooded" heat shrink tubing?
> > Other Ideas? Suggestions?
> >
> > TNX,
> > Charlie, N0TT
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|