Ah, no...The center connector on these is soldered to what appears to be
a captive center pin.
View the installation video.
If I read it correctly, the original question was about solder or crimp
center connectors
73
Roger (K8RI)
On 9/6/2016 Tuesday 7:35 AM, David Robbins wrote:
All of these din connectors are crimp style:
http://www.showmecables.com/Search.aspx?q=7%2f16+din+connector
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://wiki.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://k1ttt.net:7373
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Roger
(K8RI) on TT
Sent: Tuesday, September 06, 2016 05:42
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Selecting Coax connectors
As a "personal choice", my hands are no longer steady enough to prevent
getting solder on the outside of the center pin so I'm relegated to using
the crimp type although I'd not seen any for the DIN. I would add that I can
now hold the solder with my left hand if a lot of movement isn't required.
I "would think" if the commercial guys are using crimp, it should be
reliable enough.
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|