Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
From: w6rgs@cox.net
Date: Thu, 17 Nov 2016 10:09:26 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Yes, it is in the US.  Google is your friend.

 At 10:01 AM 11/17/2016, Herbert Schoenbohm wrote:
Is Yaesu tech support in the US? I doubt if I call Japan I could get an answer on this.

Herb, KV4FZ


On 11/17/2016 1:47 PM, w6rgs@cox.net wrote:
Herb,
Have you considered calling Yaesu tech support for that info?
73 Bill W6RGS

At 05:36 AM 11/17/2016, Herbert Schoenbohm wrote:
I have an orphan Yaesu G-8000DXA controller and would like to know if I can replace by G-450A control box with it without any modification? The plugs are the same and from the schematic the control circuit is similar. But I would like to know first before I brick the rotor on the tower. Please help.

Herb Schoenbohm, KV4FZ
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>