http://bama.edebris.com/manuals/
-----Original Message-----
From: Herbert Schoenbohm
Sent: November 17, 2016 20:50
To: K0DAN
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
Thanks for info Dan. Can you send me the link for BAMA as this site is
not known to mr?
Thanks, Herb
KV4FZ
On 11/17/2016 3:56 PM, K0DAN wrote:
I am pretty sure the G450 is not interchangeable with the G-800,
G1000, and G2800 controllers. However, the G800, G1000, and G2800 can
be interchanged. And, with suitable connector changes or use of a
pigtail, the SDX and DXA versions can also be swapped.
The schematics are on BAMA, and you can compare where the units are
similar/different.
GL es 73
dan
k0dan
-----Original Message----- From: Herbert Schoenbohm
Sent: November 17, 2016 07:36
To: towertalk@contesting.com
Subject: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
I have an orphan Yaesu G-8000DXA controller and would like to know if I
can replace by G-450A control box with it without any modification?
The plugs are the same and from the schematic the control circuit is
similar. But I would like to know first before I brick the rotor on the
tower. Please help.
Herb Schoenbohm, KV4FZ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|