EZNEC is a great tool and fun to use but it sure would be nice if it
optimized. I am not sure what you impedance is. I am sure that you can
make it direct feed 50 ohms if you can extend the boom a few feet. This
makes it very easy to adjust the DE for low SWR. GL with your project.
John KK9A
To: towertalk <towertalk@contesting.com>
Subject: [TowerTalk] Antenna model
From: john nistico <electric911inc@hotmail.com>
Date: Thu, 23 Feb 2017 01:16:36 +0000
I used eznec to model a small beam for my son who is going for his general. 2
element 20 meter yagi on a 10 ft boom the results were pretty good. Any
suggestions on how to improve? The driven element is 16fy 6 inches per side
reflector is +10%
John J. Nistico
911 Electric Inc.
516.325-8993
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|