If you have a fence company nearby and 1-7/8" OD will work go get some SS40
or Schedule 40 pipe from them.
On Fri, Mar 24, 2017 at 3:38 PM, Jim Pruitt <jpruitt67@gmail.com> wrote:
> Take a look at:
> http://www.heightstowers.com/accessories.html
> They have 2" od aluminum in 12 and 24ft lengths with thickness of 1/8" and
> 1/4". The gotcha might be the fact that it has to be shipped via motor
> freight.
>
> Also check with metal suppliers. I talked to one in Seattle that was based
> in I think LA and they carry aluminum tubing. The longest I could get was
> 20ft though rather than 24 which I thought was a bit odd.
>
> Good luck.
>
> Jim Pruitt
> WA7DUY
>
> On Fri, Mar 24, 2017 at 12:51 PM, Ed Stallman <ed.n5dg@gmail.com> wrote:
>
> > I'm in need of a 2 in OD mast pipe for my Gen Pole . I was looking at EMT
> > but I see the wall thickness is .065 . I will be lifting 115LB's , I will
> > have a pulley at the bottom of the tower so the rope will be pulling
> > striate down .. I'm not sure if EMT is strong enough for this job ?
> Anyone
> > have a recommendation , something better then EMT . 2 inch OD 1/8 wall
> > aluminum in a 10ft length is hard to find .
> >
> > Thanks Ed N5DG
> >
> >
> >
> > ---
> > This email has been checked for viruses by AVG.
> > http://www.avg.com
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|