> The movable sections of a crank-up tower are never so perfectly balanced
that they don't touch each other.? I suppose you could connect a wire
from each section to the one below such that it reaches from clamp to
clamp when the tower is fully raised and "bulges outward" in a non
interfering manner when the tower is lowered.
Isn't the tower already continuously conductive? What about the cables
that connect each section? Isn't this a non-issue?
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|