Terribly sorry. There is an English version:
http://www.hamcom.dk/VNWA/How%20to%20measure%20very%20high%20impedances.pdf
BTW, here is another take on this:
http://www.w0qe.com/Measuring_High_Z_with_VNA.html
In my opinion, and with my equipment, a two-port through measurement is probably
the better method. That said there a lot of folks with one-port measurement
equipment who can make "good enough" measurements on common-mode chokes.
Wes
On 1/2/2018 10:33 PM, Avery Davis wrote:
Wes,
This is a most interesting paper on measuring high impedances, I just
wish I could find it in English so I could read it ;-)
73,
Avery, WB4RTP
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|